Intimidator Wave IRC QRG
About This Guide
Disclaimer
Safety Notes
Contact
The Intimidator Wave IRC Quick Reference Guide (QRG) has basic product
information such as mounting, menu options, and DMX values. For more
information, download
http://www.chauvetlighting.com/product-manuals-literature/.
The information and specifications contained in this QRG are subject to change
without notice.
The following Safety Notes include important information about installation, use,
and maintenance.
·
Always connect the product to a grounded circuit.
·
Make sure the power cord is not crimped or damaged.
·
Always disconnect the product from the power source before cleaning it or
replacing the fuse.
·
Never disconnect the product from the power source by pulling or tugging on
the cord.
·
If mounting the product overhead, make sure there is adequate support for the
product's weight and always secure the product using a safety cable.
·
Make sure there are no flammable materials close to the product when it is
operating.
·
Avoid direct eye exposure to the light source while the product is on.
·
Do not touch the product's housing when the product is operating because the
housing can be very hot.
·
The product is not intended for permanent installation.
·
The product is for indoor use only. It is rated at IP20.
·
Do not expose the product to rain or moisture.
·
Always connect the product to a power source that is within the voltage range
stated on the label or rear panel of the product.
·
Never connect the product to a dimmer or rheostat.
·
Make sure to replace the fuse with another of the same type and rating.
·
Always install the product in a location with adequate ventilation.
·
Always leave at least 20 in (50 cm) between the product and adjacent surfaces.
·
Be sure that no ventilation slots on the product's housing are blocked.
·
Do not operate the product at an ambient temperature higher than
104 °F (40 °C).
·
Never carry the product by the power cord or any moving part.
·
Always use the hanging/mounting bracket to lift the product.
·
If there is a serious operating problem, stop using the product immediately.
·
Never try to repair the product. Repairs carried out by untrained people can
lead to damage or malfunction.
·
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
·
From outside the U.S., UK, Ireland, Mexico, or Benelux, contact the
distributor of record to request support or return a product.
·
From inside the U.S., UK, Ireland, Mexico, or Benelux, use the information in
Contact Us
at the end of this QRG.
the User
Manual
2
from
the Chauvet
EN
website: