Power Sources; Headphone Jack; Listening To The Radio - SOUNDMASTER BCD480 Mode D'emploi

POWER SOURCES

POWER SUPPLY
• Connect the DC external adaptor supplied (see battery compartment if necessary) to a properly installed 230 V/50 Hz
safety power socket and the DC JACK (17) of the machine.
• Ensure that the voltage is the same as that indicated on the model identification plate.
• Make sure that the external adaptor inlet is fully inserted into the appliance.
Note: During CD/MP3 playback operation
The device features an automatic switch-off function in order to keep the energy consumption low. 10 minutes after entering stop
mode, e.g. when CD playback has been stopped, the device will turn off. In order to switch the device back on again, press the
POWER button (15).
INSERTING THE BATTERIES (not supplied)
• Release the battery compartment lock (24)
Open the lid of the battery compartment (21) on the bottom.
•
Insert batteries of type 6 x 1.5 V "C" size/UM-2/R14 batteries. Please ensure that the polarity is correct to avoid
•
damage to the appliance (see the floor of the battery compartment)!
If the device is not used for a long period of item, remove the batteries to avoid the spilling of battery acid.
•
Then close the battery lid.
•
Notes:
Use batteries of the same type. Never use different types of batteries together.
•
When DC external adaptor is connected the batteries are automatically switched off.
•

HEADPHONE JACK

For headphone operation, use a headphone set with a 3.5 mm stereo jack plug plugged into the headphone jack. The
speakers are switched off.
TIME SETTING (IN STANDBY MODE)
• In POWER OFF mode, press and hold TIME/SET (11), then the HOUR of clock display will blink.
• Press TUNE- (7) or TUNE+ (8) to set the hour.
After set the hour, then press TIME/SET (11) to confirm the hour setting, the MINUTE of clock display will blink.
•
Press TUNE- (7) or TUNE+ (8) to set the minute.
•
• Press TIME/SET (11) again when finished the setting.
LCD display won't blink and the time clock is set.
•

LISTENING TO THE RADIO

Note: The preset stations will be lost if the power is interrupted.
Scanning Stations
• Press POWER (1) to turn on the unit.
Press FUNCTION (2) to select "RAD" in radio mode.
•
Press TUNE- (7) or TUNE+ (8) to tune the radio frequency,
•
• The radio frequency shows on the LCD display.
• Press and hold TUNE- (7) or TUNE+ (8) for 2 seconds. If you keep the pressing TUNE+/TUNE- button, then the
device will search to the next, or previous radio station. The display will show the respective frequency.
• For better reception, reorient the TELESCOPIC ANTENNA (23) direction.
The volume of radio is default in level 15.
•
M_BCD480 / English Instruction Manual
2