Installation; Installation Instructions; Iso Slot And Connections - Medion LIFE P62004 Mode D'emploi

Installation

Installation instructions

Before mounting disconnect the minus pole from the car battery!
There is a risk of short-circuit and electric shock!
Check whether the connections on your vehicle match those of the car
radio (refer to "Arrangement of the ISO block", P. 13).
Do not lay the cables under tension, over sharp edges or near parts that
could heat up. Ensure that you do not bend or twist the cable.
Insert the unit into the proper slot or select a location to install the unit that
will not affect the driver's ability to drive.
Connect the cable shortly before finally installing the device. Ensure that
this has been connected correctly and that the system works properly.
If changes have to be made to the vehicle, consult your vehicle dealer/
specialist workshop.
Install the unit in such a manner that no injury can be caused during heavy
braking.
If the unit is installed out of balance by over
30° from horizontal it may affect the output.
Avoid installing the unit near strong heat
sources (e. g. direct sunlight or heating air),
dust, pollution or excessive shocks. This could
damage the device.
During assembly comply with all the
instructions in these operating instructions.
Check all connections before re-attaching the car battery.

ISO slot and connections

The car radio has been designed for
assembly in a standard ISO slot. The
size must be at least 53 x 182 mm.
UK-10
Maximum installation angle!