Southbend TruVection TVGS-12SC Manuel D'utilisation page 33

T
ROUBLESHOOTING
T V G C O
RU ECTION AS ONVECTION VENS
CONTROL PANEL ACCESS AND SHUT-OFF SWITCH
To access the control panel components, remove the screw at the top of the control panel and pull the
control panel out (see drawing below). A wiring diagram for the oven is located on the side of the control
panel assembly. When the control panel is pulled out, all power to the control panel is cut off by a
shut down switch that is located directly behind and below the control panel. To re-energize the
controls for troubleshooting, pull the plunger on the shut down switch out.
Accessing Control Panel Components
BLOWER WHEEL REPLACEMENT
To replace the blower wheel, do the following:
1. Remove racks and rack guides.
2. Remove rear air baffle in front of blower wheel.
3. Loosen the two square heads on blower wheel hub.
4. Pull blower wheel from motor shaft. If blower wheel is difficult to pull off, use puller disk (available from
Southbend Technical Service Department as part number 1179100).
O ' M 1194658 P 33
WNER S ANUAL AGE