Dvd System Setup - LENCO DVT-229 Mode D'emploi

DVD SYSTEM SETUP

General Setup Process
press the DVD-SETUP button, the general
setup page, preference page will be
displayed in turn,
press
to enter the submenu.
press
PLAY/PAUSE or ENTER to confirm.
press DVD SETUP repeatedly to exit the
set-up menus.
General setup page
ASPECT RATIO DESCRIPTION
When using the DVD with the internal TV,
select 4:3/LB.
The following information applies only
when the DVD output is connected to an
external TV.
4:3 /PS (PS=Pan and Scan)
You may select if you have a normal aspect ratio (4:3) TV, although the
NORMAL/LB (letter box) is a more common (letter box) choice. In PS mode,
widescreen material will fill the screen, but at the expense of chopping off
extreme left and right edges of the original film picture. For this feature to
work, the disc must be specially coded. Such discs are uncommon.
4:3/LB (LB=Letter Box)
You may select this if you have a normal aspect ratio (4:3) TV. Widescreen
material will be shown in pure unaltered form, allowing the entire picture area
of the original film to be viewed without any side cropping. Black bars will
appear above and below the picture,
16:9
You may select this if you have a widescreen (16:9)TV, back bars may still
appear above and below the picture even if using a widescreen TV, this is
because some film directors prefer to use ultra widescreen aspect ratios e.. g .
2.35:1. This will normally be indicated on the DVD packaging.
or to select, the item, then press
or to select, then press
21