CLAS OP 5060 Mode D'emploi page 18

OP 5060
PNEUMATIC GUN FOR 370mm CARTRIDGES AND BAGS
FAULTS & BREAKDOWNS
In the event of faults and/or breakdowns of gun components, do not try to repair them. Do not use the
gun with temporary repairs or damaged or worn out components, or with non-original components
used as a replacement. Repairs shall be carried out by authorized workshops or directly by the
manufacturer. Contact your dealer.
Frequent issues
•
After charging the material and connecting the gun to the system, nothing occurs when pushing
the lever.
Cause: no feeding
Remedial action: Check disconnector opening on the system. Check pressure regulators. Check for
potential leakages in the tube.
•
Irregular or slow extrusion
Cause: very thick product
Remedial action: Increase air capacity with the flow regulator. Increase air pressure with the pressure
regulator.
•
Loss of pressure and extrusion power of the gun.
Cause: Slow front ring nut. Damaged cartridge lip
Remedial action: Tighten the ring nut properly. Check cartridge user's instructions. Replace the
damaged cartridge.
•
The gun doesn't work properly
Cause: Damaged or dirty components
Remedial action: Carry out cleaning and ordinary maintenance operations. If the issue is due to
damaged components, contact your dealer.
The guns and their tools are covered by the warranty, if not subject to wear and tear, in compliance with
European regulations. All components deemed faulty will be replaced by our technical department
with no charges, only if returned without tampering or stains and if delivered DDP to our plant. The
manufacturing company is not liable for personal injuries or damage to property due products or
gun misuses, which are expressly forbidden by this manual. In addition the company recommends to
carefully comply with the user's instructions.
WARRANTY