CLAS OP 5060 Mode D'emploi page 13

OP 5060
PNEUMATIC GUN FOR 370mm CARTRIDGES AND BAGS
•
Never use in environments where dusts or other volatile materials are present.
•
Never immerse the gun in solvents or acids.
•
When cleaning the gun, never use hydrogenated hydrocarbons based solvents and/or detergents
(1.1.1 Ethyl trichloride, methylene chloride, etc.) as they could oxidize the galvanized components
thus triggering chemical reactions also of explosive nature; never use highly acid or basic substances
when cleaning.
•
During usage, especially in the air lever release stage, keeping the gun at a distance of less than
30cm. from the face may be harmful, as the exhaust air being released through the outlets (11), may
hit your face.
•
Never turn the gun towards oneself, other people, animals or objects, other than the object
undergoing treatment.
•
Pointing the machine toward yourself, other people, animals, plants or objects other than the object
to be treated, in the event of serious malfunctioning of the machine or without the front nut, the
remote probability that the piston will be ejected exists.
•
Replenishing, cleaning and maintaining without having isolated or disconnected the compressed
air supply from the applicator.
•
Exceeding 10 bar / 145 PSI at the device's inlet.
•
It is forbidden to make any modifi cations or repairs at the device.
WARNING: Before gun start-up and usage, wear the recommended individual safety devices:
• Safety gloves
• Ear defenders
• Safety glasses.
Air feeding system Air feeding system
Connect the gun to a compressed air system featuring the following characteristics:
• Max. air humidity 5%
• Air temperature from -10° C to +70° C
• System capacity 500 l/min at least
• System equipped with lubricator; lubrication: 3-4 drops of lubricant every 1000 l/min.
The gun is equipped with a � gas male threaded connector, to which connection is possible according
to specifi c needs. The tube shall be a wound conductive tube for dynamic laying. Air consumption is
reduced and proportional to the number of times in which the product supply lever is released.
Bag refi ll
Always disconnect the gun from air feed during bag/cartridge replacement operations and any other
time the front ring nut is unscrewed from the tube.
Accidental pressure on the lever may cause the violent unload of the bag and therefore harm the
operator or other people.
Always control the refi ll material expiry date.
Never introduce damaged or not fully intact bags or cartridges in the gun.
START-UP
Max. tube length: 10m.
Operating pressure: 4-8 bar
Pressure reducer
with fi lter and gauge
58/116 PSI
Fast tap