CLAS OP 5060 Mode D'emploi page 12

OP 5060
PNEUMATIC GUN FOR 370mm CARTRIDGES AND BAGS
•
Read carefully the recommendations included and strictly comply with them.
•
Before using the gun read the instructions and strictly comply to them.
•
Before any repair, maintenance and refi ll operations, disconnect the air feed.
•
Before any repair and extraordinary maintenance operations, contact the gun dealer or trained staff .
Improper interventions will render the warranty null and void.
•
When choosing the product to extrude and before using the gun, check the product compatibility
with the work environment and the adopted individual protection devices, according to its safety data
sheet.
•
During usage, safety devices (individual protections) are to be worn on top of one's clothes, in
compliance with the product safety data sheet.
•
Using safety glasses and ear defenders is recommended in any case.
•
During tooling operations hand abrasions may be possible, therefore wearing gloves is recommended.
CAUTION: never put your hands inside the material tube!!!
Considerable risk of fi ngers and limbs being crushed. Never put your hands
inside the material tube when the power supply is connected to the
applicator. Never start up the machine without the front nut securely
screwed on and/or with material inside
To avoid any risk, do not put your hands or fi ngers inside the machine in
any case whatsoever; in the case of blockage, fault or other type of
malfunctioning,fi rst of all disconnect the machine from the power supply
and make sure that the machine discharges the pressure from the cylinder;
if you are unsure how to proceed, contact your dealer without performing
any operations on the machine..
Intended uses
•
Extrusion of sealants (silicone, mastic, glues, etc.) contained in dedicated aluminium, plastic or soft-
packs cartridges.
•
Begin the application works only after having read and understood the content of this manual and
the information provided on the technical data and safety sheet of the product you are using, wearing
all specifi ed PPE.
•
Disconnect the air from the applicator before performing any maintenance, cleaning or replenishing
and in any case that the front nut appears to be loose; the above operations are to be performed only
as specifi ed in this manual.
•
Work only in safe conditions as described in this manual, in a well-lt work area with good visibility
and good ventilation; the work area must be easy for the operator to move about in, free of any
harmful obstacles or obstructions that prevent work from being performed properly and without risk.
The presence of unskilled or unauthorised personnel must be restricted only to necessity, and the
knowledge of standard safety and fi re prevention measures is mandatory.
Forbidden uses
•
Extrusion of any specifi c product, other than those mentioned in the "Intended Uses" section.
•
Any use other than the extrusion of the aforementioned dedicated products.
•
Do not use in potentially explosive atmospheres. Do not use products generating potentially explosive
atmospheres
•
Using bulk materials
•
Using the device without tightening the front ring nut properly
•
Never cover exhaust air outlets
SAFETY