Connecting Water Hose To The Product; Connecting To Water Mains - Grundig GSBS14621FX Mode D'emploi

2.
Hose clip (3 pieces): Used to fix
the water hose on the wall.
3.
Water hose (1 piece, 5 meter
diameter 1/4 inches): Used for
the water connection.
4.
Faucet adapter (1 piece):
Comprises a porous filter, used
for connection to the cold water
mains.
5.
Water filter (1 piece *Optional):
Used to connect the mains
water to the product. Water
filter is not required if carboy
connection is available.
3.6 Connecting water hose
to the product
To connect the water hose to the
product, follow the instructions
below.
1.
Remove the connector on the
hose nozzle adaptor in the back
of the product and run the hose
through the connector.
2.
Push the water hose down
tightly and connect to the hose
nozzle adaptor.
3.
Tighten the connector manually
to fix on the hose nozzle
adaptor. You may also tighten
the connector using a pipe
wrench or pliers.
4.
Connect the other end of the
hose to the water mains (See
Section 3.7) or, to use carboy,
to the water pump (See Section
3.8).
12

3.7 Connecting to water mains

(Optional)
To use the product by connecting
to the cold water mains, a standard
1/2" valve connector must be
installed to the cold water mains
in your home. If the connector is
not available or if you are unsure,
consult a qualified plumber.
1.
Detach the connector (1) from
the faucet adaptor (2).
2.
Connect the faucet adaptor to
the water mains valve.