Connecting The Power Cord - ETI Grow Elite GL-250-MV Guide D'utilisation Et D'entretien

Installation (continued)
Attaching the V hooks
3
to chains
□ Use S hooks (not included) to
connect the chains to the
V hooks (C).
5

Connecting the power cord

NOTE: Make sure the distance between the electrical outlet and the end
of the light fi xture is less than 10 ft.
□ Plug the power cord (B) into the end of the grow light (A) and then
plug the other end of the power cord (B) into an electrical outlet.
□ Attach the power cord to the chains (not included) with cable ties (not
included).
□ Secure the power cord to the ceiling using cord clips (not included), if
applicable.
□ Use the power switch to activate the fi xture.
CAUTION: When suspension mounting, make sure
the light fi xture is located directly below the electrical
outlet. Excess cord should be secured to the chains (sold
separately) with cable ties (not included).
NOTICE: Once installed, the electrical cord should be visible over its entire 10 ft. length and:
□ Should not be concealed or extended through a wall, fl oor, ceiling, or other parts of the building structure.
□ Should not be located above a suspended ceiling or dropped ceiling.
□ Should not be permanently affi xed to the building structure.
□ Should not be subject to strain or possible physical damage.
4
Attaching the light fi xture to the V hooks
□ Slide the V hook (C) through the holes on one side of the Grow Light (A).
□ Repeat with the second V hook (C) on the other end of the Grow Light (A).
NOTE: Product should be suspended using metal chain and hooks with weight
bearing capacity exceeding 22 lbs. for ordering number 55402161 and 31 lbs. for
ordering number 55403161. S hooks must be ≤ 0.1 in. (2.5 mm) diameter to fi t the
Chain
holes in the grow light (A).
S Hook
Chain
C
A
Power switch
5
Please contact 1-855-384-7754 or further assistance.
Chain
A
WWW.ETiSSL.COM
S Hook
C
B
Cable Tie