Bissell Proheat 25A3 Serie Guide De L'utilisateur page 12

O
perations
ReadyTools cont
7. Set the ReadyTools dial to the "TOOLS"
setting. This will allow spray and suction
from the hose.
8. Attach the cleaning tool of your choice to
the end of the hose.
9. Clean by pressing the trigger to spray solu-
tion onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the trigger to suction dirty
water. Continue to clean in the area, working
in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean water
from the tap to rinse out the hose.
12. Before wrapping hose onto tool rack, lift end
of hose and stretch out to ensure all water is
cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on page 11.
15. If the ReadyTools dial becomes difficult to turn,
the diverter assembly that holds the dial may
need to be cleaned. To clean, first remove
nozzle and locate screw that holds the diverter
assembly in place. With a Phillips screwdriver,
remove the screw and set aside.
16. Remove diverter assembly; hold under
running water making sure water flows
through and around the dial. Turn the dial
about 10 times clockwise and 10 more times
counter clockwise. This should free up any
debris.
17. Wipe diverter assembly with a soft cloth and
replace back on machine. Replace nozzle.
18. Return ReadyTools dial to "FLOOR
CLEANING" setting.
12
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
7.
11.
15.
Screw
8 0 0 . 2 3 7 . 7 6 9 1 8 0 0 . 2 3 7 . 7 6 9 1
12.
Run water
through here
16.