Electrical Monitoring; Dertermining The Lubricant Output By Combining Outlets - Lincoln Quicklub SSV Instructions De Service

Owner Manual
Operating Instructions
Fig. 10 - Piston detector installed on metering device
Determining the Lubricant Output by Combining Outlets
Screw-type fittings (main metering device and secondary metering devices)
1 - Inlet fitting
2 - Delivery hole of the piston
3 - Closure plug and copper washer (M 10 x 1),
in outlet borehole installed
4 - Closure plug (M 11 x 1), piston (champfered)
Page 8/19
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
00002634
Fig. 11 - Install the outlet fittings and closure plugs in accordance with the dosage
5 - Outlet fitting assembly
6 - Valve body with clampinf ring
7 - Cutting ring
8 - Coupling nut
Electrical monitoring (microprocessor control)
• A piston detector (initiator) which has been installed on a mete-
ring device instead of a piston closure plug (M 11 x 1) monitors
the pump lubricating time and brings it to a close after all the
pistons of this metering device have dispensed their lubricant
quantity.
• If there is a blockage in the system or if the pump reservoir is
empty, the piston detector can no longer record the piston move-
ments. The switching off signal is not transmitted to the printed
circuit board. A fault signal occurs.
Important ! For the system monitoring it is recommended that one
SSV metering device with pre-assembled piston detector be
used per lubrication circuit. These special metering devices must
be ordered separately for each lubrication system. Refer to Parts
Catalog.
• The pre-assembled metering devices have the designation
SSV ... - N (they are available for SSV 6, 8, 10 and 12). They
must be installed in the system instead of a normal metering de-
vice.
9 - Junction channel
10 - Closure plug (M 10 x 1) with hex.
socket head and sealing edge,
replaces pos. 3
2.2A-20001-F06
1 0 1 2 c 9 6