Atomic Watch - DETOMASO DIGITAL DT1009 Instructions D'entretien

Atomic watch

Minute hand
Hour hand
Digital display
There are four main feature modes.
Use the S1 button to display the various modes in the following order:
Automatic reception
The signal status is checked automatically every day at 3.00 am local time. If the signal cannot be
found, the automatic check is repeated at 4.00 am and then again at 5.00 am. If the signal still
cannot be found, the next check is the next day at 3.00 am again. Placing the watch near a window
may improve signal reception.
Manual reception
In any mode, press and hold the S1 button for 3 seconds to start the manual reception search. The
RC tower symbol flashes while the search is running and the bar symbol shows the signal strength.
If the search is successful, the tower symbol remains in the display. If the reception is too weak or
cannot be found within 3 minutes, the tower symbol disappears.
Setting/adjusting the time
Press and hold the S2 button until the digital display flashes. Press the S1 button until the desired
time zone (eU) appears. Press the S2 button to choose the time zone. To set the year, press the S2
button five times. Use the S1 button to choose the year.
S1-Button
Second hand
S2-Button
Digital display
Time — Date — seconds/weekday — time zone
Features
• Analogue time display showing h, min, sec
• Digital time display showing h, min, sec
• Fully automatic date display showing day,
date, month
• Radio signal reception (DCF 77.5 KHz)
• Signal reception either manual or automatic
• 24 hour time display
eN
24