Initial Start Up; Application; Power Supply Connection; Checking The Running Direction - Intimus 16.50 SmartShred Instructions D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB
3

Initial start up

3 .1 Application

CAUTION!
Risk of injury! Damage to the cutting me-
chanism!
The shredder should only be fed with paper
or cardboard!
Shredding other data carriers can cause
injury(e.g. by splintering of hard materials)
or may damage the shredder (e.g. destruc-
tion of the cutting system).
The 16 .50 SmartShred shredder is used in all areas
where large quantities of printed material need to be
shredded.
The machine can shred cardboard and crumpled pa-
per as easily as it shreds smooth paper.

3 .2 Power supply connection

The maximum value for loop impedance at the
mains connection point is 0.5 Ohms.
The conductor cross-section of the power supply
line should be of a magnitude so as to cause a 15%
voltage drop in the case of a machine blockage (in-
hibit current = 6 x nominal current).

3 .3 Checking the running direction

1
1
Emergency-stop rail
fig. 3 Emergency-stop rail
1 . Free the emergency-stop rail (pull out the rail)
(fig. 3) on the shredder feed table. Switch on the
main switch (fig. 4/2) i.e. to position „1".
2 . Turn the key selector switch (fig. 4/1) to the right.
¾ The display appears.
3 . Press the green start button (fig. 4/3).
4 . Check that the shredder is running in the correct
direction and correct the phase relation at the con-
trol box if necessary.
Now that everything has been correctly assembled and
connected, you can proceed to operating the machine.
94709 1 02/18
DANGER!
Risk of death by electrocution!
Correcting the phase relation at the control
box may only be carried out by a qualified
electrician!

3 .4 Initial commissioning

Switch on, set the language and time. See „Display",
p. 14.
4

Controls

4 .1 Switches and Keys

000212
1
Key selector switch
2
Main switch (emergency stop)
3
Start button, green
4
Reset button, yellow
5
Stop button, red
6
Display
fig. 4 Controls
1
= Key selector switch
a) Left: manual operation
The „Manual operation" screen appears. Manual
control of the machine via the display.
16.50 SmartShred
6
5
4
3
2
1
000119
13

Publicité

Table des Matières
loading

Table des Matières