Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
H
Adjust the vertical position
(1) Adjust the vertical position, then tighten the two M8 x 15 mm hexagon socket head cap
bolts on the sides of the setting plate (
(2) Tighten the two M8 x 45 mm hexagon socket head cap bolts at the bottom of the setting
plate to support your vertical adjustment (
The projected image is raised or lowered accordingly. After you make this adjustment, you may need to
readjust the vertical tilt, as described on page 24.
I
Adjust the forward/backward slide
Loosen the four screws and adjust the slider of the setting plate.
Screws (4)
After you finish making all of the adjustments in steps
J
Turn off the display of the test pattern or computer image
Press the Esc button on the remote control or control panel to turn off the test pattern.
Warning
Tighten all screws firmly. If the screws are not tightened firmly, the projector or setting plate
may fall and cause personal injury or property damage.
A
).
B
).
M8 x 45 mm
hexagon socket
head cap bolts (2)
25
E
I
to
, tighten the screws.
Publicité
Table des Matières
