Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Align the slider with the mark on the slider measure that is a distance (a+x) equivalent to the
distance (a) plus the thickness of the board (x). See the tables on pages 12 to 15. The
recommended range for projection distance (a) is 2.76 to 14.57 in. (7 to 37 cm).
C
Attach the setting plate to the wall plate
(1) Position the cables between the two screws and pass the cables through the setting plate
A
(
).
(2) Hang the setting plate hook onto the wall plate bar (
Caution
Take care not to trap the cables between the setting plate and wall plate.
(3) Tighten the two M8 x 15 mm hexagon socket head cap bolts and two M8 x 45 mm hexagon
socket head cap bolts supplied with the setting plate so that the setting plate becomes
vertical against the wall (
Use the two M8 x 45 mm hexagon socket head cap bolts to adjust the vertical position.
s 25
Setting plate
Screws (4 )
Slider measure
C
).
19
B
).
Wall plate
Wall plate bar
Setting plate hook
Cables
M8 x 15 mm hexagon socket
head cap bolts (one on left
and one on right)
M8 x 45 mm hexagon
socket head cap bolts (2)
Publicité
Table des Matières
