EGO CS1800 Guide D'utilisation page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A chain saw is intended for two
handed use. Serious injury to the
operator, helpers, and/or bystanders
can result from one-handed
operation (Fig. 6).
Always cut with the unit running
at full speed. Fully squeeze the
switch trigger and maintain cutting
speed.
Push and Pull – The reaction force
is always opposite to the direction
the chain is moving where wood
contact is made. Thus, the operator
must be ready to control the PULL
when cutting on the bottom edge of
the bar, and the PUSH when cutting
along the top edge (Fig. 7).
Avoid unintentional contact
with the stationary saw chain or
guide bar rails. These can be very
sharp. Always wear gloves and long
pants or chaps when handling the
chain saw, saw chain, or guide bar.
Never operate a chain saw
that is damaged or improperly
adjusted or that is not
completely and securely
assembled. Be sure that the saw
chain stops moving when the trigger
switch is released.
When bucking, secure the work piece prior to cutting. When felling or
pruning, identify and secure hazardous branches.
Aggressive or abusive cutting or misuse of the chain saw can cause
premature bar, chain, and/or sprocket wear, as well as a broken chain or
bar, leading to kickback, chain throw or the ejection of material.
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1800/CS1800-FC
6
BRUSHLESS
7
Pull
Push
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cs1800-fc

Table des Matières