Chain Brake - EGO CS1800 Guide D'utilisation

KICKBACK SAFETY DEVICES ON THIS CHAIN SAW

Chain Brake

The chain saw comes equipped with a chain brake, which stops both the motor and
the motion of the chain when kickback occurs. The chain brake can be activated by
the forward motion of the chain-kickback brake handle as the saw rotates backward
during kickback; it can also be activated by the inertial forces generated during rapid
pushback.
WARNING :
Make sure that the chain brake is working properly before using the chain saw. The
chain-kickback brake handle should move back and forth easily.
To test the operation of the chain brake,
perform the following steps (Fig. 1):
◾
Place the chain saw on a flat bare
surface and make sure no objects
or obstructions that could come in
contact with the bar and chain are in
the immediate vicinity.
◾
Disengage the chain brake by
pulling the chain-kickback brake
handle towards the front handle.
◾
Start the chain saw.
◾
Push the chain-kickback brake handle towards the front of the saw. A properly
functioning hand brake will stop the movement of the chain immediately. If the
chain brake is not working properly, do not use the chain saw until it has been
repaired by a qualified service technician.
WARNING :
WARNING :
chain brake may deteriorate. Always keep the device clean.
12
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1800/CS1800-FC
Never modify or attempt to disable the chain brake.
Confirm that the chain brake works properly before each use.
If the chain brake is clogged with wood chips, the function of the
1
Chain kickbanck brake
handle in operationg position
Chain kickbanck brake
handle in brake position