Plebani Bunny Mode D'emploi page 14

- Security lock with lock
- A simple one hand operation allows adults only to open it in both directions
- Suitable for openings of 71-98 cm. with the possibility of extension to 115 cm.
- Also suitable for stop pets
PARTS
A - Gate Panel
B - Gate Frame
C - Extension Panels
D - Locking Knob
E - Extension Pin
F - Tension Bolt
G - Tension Screw
H - Rubber Pad
I - Fixing Cap
L - Lower Locking Rod
M - Threshold
(Parts F, G, H and I are placed inside a small box fixed to the gate and you will also find
small screws for fixing caps (I)).
WARNING: As soon as you take "Bunny" gate out from the box you will notice space
between the frame (B) and the panel (A) (Fig. 1). Do not be alarmed, it is normal that there
is this space.
INSTALLATION
Our gate adapts to different sizes of openings depending on the extension panels (C) you
will use; choose the most suitable configuration according to the size of your opening (Fig.
2).
IMPORTANT: "Bunny" safety gate is sold with 2 panels (C) INCLUDED. You can purchase
additional panels at your dealer.
ATTENTION!:
- The MAXIMUM width of the opening where you can fix the gate is 115 cm.
- Do not place extensions (C) on the same side (Fig. 3). Always place them by following the
diagram in Fig. 2 according to the required size.
Install the gate with the locking knob (D) on opposite side of area accessible to child (Fig.
4).