Elcometer 319 S Guide D'utilisation page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 75
R
7 TAKING A READING (continued)
3
Press 'Hold' followed by 'Save' to save the reading data into the
batch memory.
If the 'Manual Logging' setting is "Save only', 'Hold' is not displayed.
4
Simply press 'Save' to save the reading data into the batch memory.
4
To exit batching, press the
Batching'.
Using 'Interval Logging':
Before you start, if you intend to take readings over a long period of
time check that the batteries are in good condition; if in doubt, insert
new batteries -
Consider the use of an external temperature probe; holding the
surface temperature probe integrated into your gauge against a
surface over an extended period of time may not be practical - see
Section 8 'Using External Temperature Probes' on page en-12.
1
Create a new 'Interval Logging' batch and set the required
logging time interval - see Section 10.1 on page en-15.
2
Place the rubber tip of the surface temperature sensor against
the surface, preferably at an angle of 90°, and keep it in this
position.
The trend indicator next to the parameter indicates if the value is
4
increasi
ng (
indicates that the value is stable.
3
Press 'Start' to start logging, the reading data is saved
automatically at the set interval.
A delayed start time can be set when creating an 'Interval Logging' batch.
4
The gauge will automatically start once the set time has elapsed.
If an 'Auto Switch Off' time is set, the gauge will appear to switch off after
4
the set time delay but whilst you are logging, it will remain on in a reduced
power state. In this state, during interval logging, the gauge will continue
reading data into batch memory at the set logging interval. When the
gauge is next switched on, the batch will reopen.
4
Press 'Stop' to stop logging data, followed by 'Yes to confirm or
'No' to escape and continue logging.
5
To exit batching, press the
Batching'.
en-11
see Section 4.1 'Fitting the Batteries' on page en-4
5
) or decreasing (
softkey followed by 'Exit
6
).
The absence of a trend indicator
softkey followed by 'Exit
www.elcometer.com
.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

319 t

Table des Matières