Water Connection; Electrical Connection; Safety Devices Installed - CombiSteel 7280.0026 Notice D'utilisation

EN
To lift the machine safely
the pallet truck forks should
protrude at least 10 cm on the
opposite side of the base. Wear
protective gloves and safety
shoes before removing the
packaging.
LODGE A PIECE OF
PROTECTIVE CARDBOARD

4.3 Water connection

The connections must be carried
out by qualified personnel in
compliance with the laws in
force in the place of installation.
Make sure the water supply pressure is
between 100÷500 kPa dynamic (1÷5 Bar)
for the atmospheric boiler version, and
between 200÷500 kPa dynamic (2÷5 Bar)
for the version with mains pressure boiler.
This measurement must be carried out
during the first water filling; if the pressure
is higher, install a pressure reducer at the
source. If the water has a high content
of calcium and magnesium salts, with
hardness > 20°f, it is advisable to install a
water softener. Each machine is supplied
with a water filling rubber hose with a 3/4"
connection which must be connected to the
mains water supply.
34
The inlet water temperature
must be between 10°C and
50°C.
If the "ES" energy saving system or the
"S" water softener are installed, the inlet
water temperature must not exceed 25°C.
The drainpipe must be connected to room's
main discharge; it is advisable to insert
a floor drain siphon. In the version with
incorporated drain pump (option), the
drainpipe already has an internal siphon
(max. drain height H 800 mm).

4.4 Electrical connection

The electrical connection must
be carried out by a qualified
electrician, in compliance with
local regulations.
Make sure the equipment is connected to
an efficient earthing system and that the
line voltage matches that specified on the
machine's data plate.
Connect the power cable to an
easily accessible 30 mA thermal-
magnetic wall circuit breaker
with contact gap of at least 3
mm.
Make sure the power cable has not been
damaged or crushed during handling.
If necessary, it must be replaced
only by an authorised installer.
Do not plug the power cable in
before completing installation
and fitting the cover panels.
The machine must be connected
to an equipotential system,
connecting the cable in the rear
terminal next to the symbol.
CONNECT USING CABLE
OF MIN. 10 mm² SECTION

4.5 Safety devices installed

The machine has a number of safety devices
in place.
- The internal wiring has an amperometric
thermal relay which stops the wash cycle in
case of a pump fault.
- A micro magnetic sensor stops the wash
cycle in case of accidental opening of the
door.
- Manual reset thermostats switch off the
heating elements in case of overheating of
water.
- An overflow pipe keeps the tank water
level constant.
- A safety pressure switch prevents the
water inside the machine from exceeding
the maximum level.
The manufacturer declines any
liability for damage or injury
resulting from tampering with
or the non-use of these devices
or due to non-compliance with
the above instructions and the
electrical safety regulations
in force in the country of
installation.
EN
35