Bestway LAY-Z-SPA Manuel Du Propriétaire page 9

of water, and disposal of water, please see section
"MAINTENANCE".
• Regarding the information pertaining to the installation, thanks
to refer to the below paragraph of the manual.
• Please examine equipment before use. Notify Bestway at the
customer service address listed on this manual for any
damaged or missing parts at the time of purchase. Verify that
the equipment components represent the models that you had
intended to purchase.
• This product is not intended for commercial use.
Indoor and outdoor & above ground & portable wiring & portable
spa
WARNING: The selected location has to be able to support of
supporting the expected load.
WARNING: An adequate drainage system has to be provided to
deal with overflow water for both indoor and outdoor installations.
• Always keep the spa cover on to minimize heat loss during
heating of the spa between uses (but not while it is being
used). Ensure the cover is fitted tightly, as per instructions to
maximize insulation. It shall be recommended that the cover,
when not in use, should be kept off the ground to retain its
cleanliness (particularly the surface in close proximity to the
water spa water surface). The cover should be stored in an
appropriate location, where it cannot be damaged, or cause
damage.
• Check the set water temperature and consider lowering it for
the times when the spa will typically not be in use.
• Depending on external conditions, consider turning off the
heater entirely if not using the spa for an extended period of
time (where the spa provides this option, but still maintains
residual disinfection/pH-values).
• It is recommended to use an insulating ground cloth underneath
the spa to minimize heat loss through the bottom of the spa.
• Maintain clean filters to preserve appropriate working conditions
for the pump and avoid unnecessary water replacement and
re-heating.
NOTE:
SAVE THESE INSTRUCTIONS
SELECTED LOCATION
9