Metabo PowerMaxx PA Notice D'utilisation page 10

your eyes, wash them with clean water and seek medical
attention immediately!
Warning - general danger!
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
4. Overview
See page 1.
1 Mode display / Capacity and signal display:
- Press the button (2), the LEDs indicate the
battery charge level.
- The battery pack is almost flat and must be
recharged if one LED is flashing.
- If all LEDs are flashing, the device is
overloaded and too hot and automatically
switches off after one minute.
2 On/off switch
3 12V connector (only for HJA 14.4-18 (6.570...)
4 USB port
5 Battery pack release button
6 Battery pack (*not in scope of delivery)
5. Commissioning
Charge the battery pack (6) before use.
Recharge the battery pack if performance
diminishes.
Inserting
Slide in the battery pack (6) until it engages.
6. Use
6.1 Charge/operate USB device
Connect the USB device with a suitable cable with the
Power Adapter by plugging into the USB port and
start the power supply pressing (4) (for at least
0,5 seconds) the on/off switch (2). Mode display (1)
illuminates green and shows the current battery
charge status.
Only connect USB devices which are
compatible with the USB standard. Using
incompatible devices can lead to malfunctions,
damage or injury.
Disconnect the USB device after use or after
charging from the Power Adapter.
After a period of 7 hours, the Power Adapter will
switch off automatically. Press (at least
0.5 seconds) the on/off switch (2) again to start the
power supply for another 7 hours.
Switching off the USB power supply (4):
Press on/off switch (2) for approx. 2 seconds.
6.2 12V connector for operation of the heated
jacket HJA 14.4-18 (6.570...)
Connect the heated jacket HJA 14.4-18 using the
corresponding cable to the Power Adapter by
plugging in the 12V connector (3) and start the power
10