F.Bertazzoni REF24BMFXNV Mode D'emploi page 10

7) Loosen the screw
part ; install the replacement door-stopper (left)
provided (in the plastic bag) and part
the left side, using the screw
appliance for future reference.
8) Loosen the screws used to secure the middle hinge
and remove the middle hinge. Then remove the lower
door.
9) Place the lower door on a smooth surface with its
panel facing upwards. Loosen the screw
down part and part , install the replacement door
stopper (left) provided (in the plastic bag) and part
(stop block) on the left side, using the screw
Keep part with the appliance for future reference.
10
and take down part and
(stop block) on
. Keep part with the
Door stopper
Stop block
Self-tapping screw
and take
Door stopper
Stop block
Self-tapping screw
10) Move the screw hole covers on the middle cover
plate from left to right (as shown in the figure below).
11) Tip the refrigerator backwards and remove part
①
②
③
④
⑤
Lower part of hinge (right)
Adjustable bottom foot
Adjustable bottom foot
Self-tapping screws
Adjustable bottom foot
12) Remove part
remove the lower hinge pin, move it to the reverse
hole site and tighten it into position. Then install part
on the lower hinge pin.
13) Replace the items removed in step 11, move part
to the left side, and then secure them with screws
.
. Install part last of all.
Lower part of hinge
(left)
14) Mount the lower door on the lower hinge pin and
hold it in place. Rotate the central hinge by 180°,
rotating the washer on its axis so that it is on the
bottom side, adjust the central hinge to the appropriate
position and then install it, making sure the bottom
door is in a secure position.
Note:
washer may stick
to lower door.
from the lower hinge pin, free and
Washer
.