ENGLISH
Contents
Safety information
For your safety and correct operation of the appliance, read this
manual carefully before installation and use. Always keep these
instructions with the appliance even if you move or sell it. Users must
fully know the operation and safety features of the appliance.
Recommendations and suggestions
• The manufacturer will not be held liable for any damages resulting
from incorrect or improper installation.
• The minimum safety distance between the cooker top and the
extractor hood is: for electrical and for gas hob 500mm.
• If the instructions for installation for the gas hob specify a greater
distance, this must be respected.
• Check that the mains voltage corresponds to that indicated on the
rating plate fixed to the inside of the hood.
• For Class I appliances, check that the domestic power supply
guarantees adequate earthing.
• Connect the extractor to the exhaust flue through a pipe of
minimum diameter 120 mm. The route of the flue must be as short
as possible.
• Do not connect the extractor hood to exhaust ducts carrying
combustion fumes (boilers, fireplaces, etc.).
• If the extractor is used in conjunction with non-electrical appliances
(e.g. gas burning appliances), a sufficient degree of aeration must
be guaranteed in the room in order to prevent the backflow of
exhaust gas. When the cooker hood is used in conjunction with
appliances supplied with energy other than electric, the negative
pressure in the room must not exceed 0,04 mbar to prevent fumes
being drawn back into the room by the cooker hood.
• If the supply cord is damaged, it must be replaced from the
manufacturer or its service agent.
4
7
8
9
4
10
1 1
12
12