Fault Diagnosis Table; Operating Broncolor Ballast Units From A Motor-Generator Set - Broncolor HMI F1600 Mode D'emploi

10. FAULT DIAGNOSIS TABLE

Fault detected
Short circuit
Bulb goes out
Wrong lamp
detected
Supply voltage
over 265 VAC
Supply voltage
below 85 VAC
Operating
temperature
exceeded
More than 10
ignition attempts
Technical fault
11. OPERATING BRONCOLOR BALLAST UNITS FROM A MOTOR-
GENERATOR SET
Ballast units are suitable for operation with motor-generator sets, in so far as the voltage under
all load conditions (including capacitive loads) is within the tolerance limits of 200 – 260 V or
95 – 135 V. Experience shows that this usually requires electronically-stabilised motor-generators.
Unstabilised motor-generators can produce voltage peaks of 300 V and over. This may cause
damage for which Bron Elektronik AG accepts no liability.
How to Start/Stop high speed
reset (4) (5a)
Restart blinks blinks
Restart blinks off
Restart blinks off
Restart blinks blinks
Restart blinks blinks
Allow to blinks off
cool
Allow to blinks off
cool
Service blinks blinks
station
normal low noise 800 W
(5b) (5c) (7a)
off off (on)
blinks off (on)
off blinks (on)
blinks off (on)
off blinks (on)
off off (on)
blinks blinks (on)
blinks blinks blinks
1600 W Earth
(7b) (3)
(on) on
(on) on
(on) on
(on) on
(on) on
(on) on
(on) on
blinks on
11