Compliance With Standards; Ec Conformity Declaration - pizzato HX Serie Mode D'emploi

Interrupteurs de sécurité à charnière
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
- with 2 channels controlled by a safety module: can be used up to category 3 and PL
d, only if mechanical faults can be excluded.
It should be noted that the series connection of two or more devices reduces the self-
monitoring capacity of the system, see ISO/TR 24119.
Performance Level (PL):
Safety category:
Mission time:
Max. operating altitude:
Max. actuation frequency:
Mechanical endurance:
Max. actuation speed:
Min. actuation speed:
Mounting position:
Storage temperature:
Versions with mechanical contact block HX ••22-•••:
Safety parameters:
Positive opening force:
Versions with electronic contact block HX •EE1-•••:
MTTFd (single channel):
PFH
:
D
DC:
8.3Electrical data and operating temperature
Versions with mechanical contact block HX ••22-•••:
Rated impulse withstand voltage Uimp:
Conditional short circuit current:
Pollution degree:
Cable, fixed installation
Cable, flexible installation
Cable, mobile installation
Thermal current Ith
Rated insulation voltage Ui
Protection against short circuits
(fuse)
24 V
Utilization
category
125 V
DC-13
250 V
24 V
Utilization
category
120 V
AC-15
250 V
Versions with electronic contact block HX •EE1-•••:
Rated operating voltage Ue
Rated operating current Ie
Minimum operating current
Maximum switching load
Consumption at Ue voltage
Rated impulse withstand voltage Uimp
Resettable internal protection fuse:
Overvoltage category
Electrical data of IS1/IS2 safety inputs
Rated operating voltage Ue
Rated current consumption
Electrical data of OS1/OS2 safety outputs
Rated operating voltage Ue
Output type
Maximum current per output Ie
Short circuit detection
Overcurrent protection
Duration of the deactivation impulses at the safety outputs < 300 µs
Permissible capacitance between outputs
Permissible capacitance between output and ground
Electrical data of O3 signalling output
Rated operating voltage Ue
Output type
Maximum current per output Ie
Short circuit detection
Overvoltage protection
Actuation data
Response time upon inputs deactivation:
- Typical 7 ms
- Maximum 12 ms
Response time on door opening:
- Typical 7 ms
- Maximum 12 ms
Up to PL e acc. to EN ISO 13849-1:2015
Up to cat. 4 acc. to EN ISO 13849-1:2015
20 years
2000 m
600 operating cycles/hour
1 million operating cycles
90°/s
2°/s
any
-40°C ... +70°C
B
: 5,000,000
10D
0.65 Nm
2413 years
1.24E-09
High
4 kV
1000 A acc. to EN 60947-5-1
3
Cable
M12 connector
9x0.34 mm
8-pole
2
-25°C ... +80°C
-25°C ... +80°C
-5°C ... +80°C
-5°C ... +80°C
/
/
3 A
2 A
30 Vac
250 Vac
36 Vdc
3 A 500 V
2 A 500 V
type gG
type gG
2 A
2 A
0.4 A
/
0.3 A
/
3 A
2 A
3 A
/
3 A
/
24 Vdc (-15% ... +10%) SELV/PELV
0.25 A
0.5 mA
6 W
< 1 W
1.5 kV
1.1 A
III
24 Vdc
5 mA
24 Vdc
PNP
0.25 A
Yes
Yes
< 200 nF
< 200 nF
24 Vdc
PNP
0.1 A
No
Yes
Cable, fixed installation
Cable, flexible installation
Cable, mobile installation
Thermal current Ith
Rated insulation voltage Ui
Protection against short circuits
(fuse)
Utilization category
DC-13

8.4 Compliance with standards

EN 60947-5-1, EN 60947-1, EN 60204-1, EN ISO 14119, EN ISO 12100,
EN 60529, ISO 20653, IEC 61508-1, IEC 61508-2, IEC 61508-3, EN ISO 13849-1,
EN ISO 13849-2, EN 62061 , EN 61326-1, EN 61326-3-1, EN 61326-3-2, UL 508,
CSA 22.2 No.14
8.5 Compliance with directives
Machinery Directive 2006/42/EC, EMC Directive 2014/30/EU, RoHS Directive
2011/65/EU
9 SPECIAL VERSIONS ON REQUEST
Special versions of the device are available on request.
The special versions may differ substantially from the indications in this instruction
sheet.
The installer must ensure that he has received written information from the support
service regarding installation and use of the special version requested.
10 DISPOSAL
At the end of service life product must be disposed of properly, according to the
rules in force in the country in which the disposal takes place.
11 SUPPORT
The device can be used for safeguarding people's physical safety, therefore in case of
any doubt concerning installation or operation methods, always contact our technical
support service:
Pizzato Elettrica Srl
Via Torino, 1 - 36063 Marostica (VI) - Italy
Telephone +39.0424.470.930
E-mail tech@pizzato.com
www.pizzato.com
Our support service provides assistance in Italian and English

12 EC CONFORMITY DECLARATION

I, the undersigned, as a representative of the following manufacturer:
Pizzato Elettrica Srl, Via Torino, 1 - 36063 Marostica (VI) - Italy
hereby declare that the product is in conformity with whatever prescribed by the
2006/42/EC Machine Directive. The complete version of the present conformity
declaration is available on our website www.pizzato.com
Marco Pizzato
DISCLAIMER:
Subject to modifications without prior notice and errors excepted. The data given in this sheet are accurately
checked and refer to typical mass production values. The device descriptions and its applications, the fields
of application, the external control details, as well as information on installation and operation, are provided
to the best of our knowledge. This does not in any way mean that the characteristics described may entail
legal liabilities extending beyond the "General Terms of Sale", as stated in the Pizzato Elettrica general
catalogue. Customers/users are not absolved from the obligation to read and understand our information
and recommendations and pertinent technical standards, before using the products for their own purposes.
Taking into account the great variety of applications and possible connections of the device, the examples
and diagrams given in the present manual are to be considered as merely descriptive; the user is deemed
responsible for checking that the specific application of the device complies with current standards. This
document is a translation of the original instructions. In case of discrepancy between the present sheet and
the original copy, the Italian version shall prevail. All rights to the contents of this publication are reserved in
accordance with current legislation on the protection of intellectual property. The reproduction, publication,
distribution and modification, total or partial, of all or part of the original material contained therein (including,
but not limited to, texts, images, graphics), whether on paper or in electronic form, are expressly prohibited
without written permission from Pizzato Elettrica Srl.
All rights reserved. © 2022 Copyright Pizzato Elettrica.
10/30
Cable
M12 connector
8x0.34 mm
2
-25°C ... +70°C
-25°C ... +70°C
-5°C ... +70°C
-5°C ... +70°C
/
0.25 A
32 Vdc
1A type F
1A type F
24 V
0.25 A
8-pole
/
0.25 A
32 Vdc
0.25 A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hx c serieHx l22 serieHx h22 serieHx ee1 serie

Table des Matières