Cal Zone Quest 2000 Ozonator - CalSpas Aqua SQ63 Guide D'utilisation

Cal Zone Quest 2000 Ozonator

This plan and its chemical dosages are intended for
spas equipped with the optional Cal Zone Quest 2000
Ozonator (portable spas only) or Del Zone Eclipse
(in-ground models only). The chemical references are
designed for Cal Spas chemicals only.
Start Up
1. Follow the Spa Start Up procedures for Chlorine
"Clear Water Plan".
2. Set the spa's filtration time for "F-4". This activates
the ozonator and produces the ozone gas. (Follow
the instructions in the owner's manual)
Note: Filtration time may need to be increased with
heavy bather load.
Day One (Monday)
1. Test spa water using chlorine "Test Strips". (You
will need to use a small amount of chlorine as a
supplemental sanitizer.)
2. Based on the Test Strip readings:
• First adjust total alkalinity (acceptable range of
80-120 ppm),
• Then adjust the pH if needed. (Range is
between 7.2 to 7.8.)
• Add 1 tablespoon of Chlorine Granules.
• The recommended level of Chlorine is 1-3
ppm.
3. Add 2 oz of "Stain and Scale Defense".
4. Remove dirty filter from the spa and rinse off.
5. Place your extra clean filter cartridge back into the
spa.
6. Vacuum debris from the bottom of your spa with
the "Spa Vacuum".
Day Two (Friday)
1. Test spa water using Chlorine Test Strips.
2. Based on the Test Strip reading:
• Adjust total alkalinity, then the pH if needed.
• Add 1 tablespoon of Chlorine Granules (if
needed).
3. Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
minutes with cover off.
4. Replace cover.
2007 Portable Spa Owner's Manual
LTR20071001, Rev. B
Water Quality Maintenance
Page 25