Possible Causes - Rowenta DR70 Serie Mode D'emploi

IS THERE A PROBLEM ?
PROBLEMS
There is no steam. The appliance is not plugged in,
or not switched on.
The water level is too low.
The steam pump has not been
primed.
You are using the appliance for
the first time.
The water tank is not fully in
place.
The appliance It is not plugged in, or not
does not heat. switched on.
Water leaks. The water tank is not fully in
place or the stopper is not closed
properly.
Steam rate Calc Sealing.
decreases.
The steam leaves You are using water with
stains on the fabric additives.
or the appliance
The appliance has not been
spits.
cleaned enough after the
descaling operation.
You are using other liquids than
white vinegar to descale the
product.
Appliance steams The steam trigger is on the lock
continuously. position.

POSSIBLE CAUSES

SOLUTIONS
Check that your appliance
is correctly plugged in and
switched on.
Unplug your appliance and refill it.
Press the steam trigger continu-
ously for a few seconds to begin
steaming.
Press the steam trigger continu-
ously for a few seconds to begin
steaming.
Ensure that stopper is closed and
that the water tank snaps when
put into place.
Plug in your appliance and
switch on.
Ensure that stopper is closed and
that the water tank snaps when
put into place.
Refer to 'ANTI CALC section in
instructions for use.
Never add any additive in the
water tank.
Read carefully the 'ANTI CALC'
section in instructions for use.
Use only white vinegar during
'ANTI CALC' procedure.
Unlock the steam trigger.
27