HTW P14 Serie Mode D'emploi page 22

2) Elongate the exhaust pipe and snap the flat end of the exhaust pipe joints into the hole of
the window sealing plate assembly (as shown in Fig.5 and Fig.6) .
Notes: 1. the flat end of the exhaust pipe joints must be snapped into place.
2. The pipe cannot be distorted nor has substantial turning (greater than 45 °). Keep
the ventilation of the exhaust pipe not blocked.
Important Notice
The length of the exhaust hose shall be 280~1,500mm, and this length is based on the spe-
cifications of the air conditioning. Do not use extension tubes or replace it with other different
hoses, or this may cause a malfunction. Exhaust host must be not blocked; otherwise it may
cause overheating.
Fig. 5 Fig. 6
22