Safety Instructions And Recommendations - Sagem PHOTO EASY 255 Livret D'utilisation

S
AFETY INSTRUCTIONS AND RECOMMENDATIONS
• Do not install your PHOTO EASY 255 printer in a humid room
(bathroom, laundry, kitchen, etc.), or within 1.50 m of a tap or water
source, or outside. The printer should be operated within an ambient
temperature range of 10 °C to 35 °C.
• Do not install your printer in a location where there is a noticeable
amount of dust floating in the air. Such dust can degrade the print quality
of your photos.
• Only the power supply provided with the printer should be used. Connect
this to the mains in accordance with the installation instructions in this
user guide and the information on the identification label affixed to the
power supply (voltage, current, mains frequency). As a precaution, in
case of danger, the mains adapters act as a disconnecting mechanism for
the 230V power supply. They should be placed near the device and
should be easily accessible.
• Never open the cover of the film cartridge compartment during
printing. This could break the film and cause printer malfunction.
• Only use SAGEM consumables, if not you are likely to damage the
equipment and invalidate the guarantee. To obtain the references of the
consumables (refer to the paragraph Replacement of consumables,
page 25).
• The CE marking certifies that the product meets the main requirements of
the European Parliament and Council directive 1999/5/CE on
telecommunications terminal equipment, regarding safety and health of
users, and regarding electromagnetic interference.
The declaration of compliance can be consulted on the site
www.sagem.com category "support", or can be requested at the following
address:
E - Customer relations department
4 rue du petit Albi - 95800 Cergy Saint-Christophe - FRANCE
- 2 -