To Change The Ribbon - Sagem PHOTO EASY 255 Livret D'utilisation

T
O CHANGE THE RIBBON
Remark : Use DSR400 or DSR400T consumables only. These are specially designed to
provide you with optimum print rendering.
For this purpose, the printer must read the chip card delivered with each
consumable kit after any new kit installation.
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Take the PLUG N'PRINT card delivered with the ribbon and the photo
paper. Insert it in the drive located on the front panel of the printer. The
PLUG N'PRINT card is recognised and read by the printer ; the
following message is displayed at the end of the procedure "Transfer
OK (40 or 120), Remove card".
2. Remove the PLUG N'PRINT card ; the display returns to the welcome
screen.
3. Take the new ribbon out of its packaging and make sure that the film is
stretched after removing the card (A).
4. Open the external flap located on the right-hand side of the printer.
5. Lift the locking lever and remove the used ink ribbon.
6. Install the ribbon in the position shown in the illustration below.
7. Lift the locking lever and push in the film cartridge until it touches the
back of the compartment the locking lever must be locked after
insertion.
8. Close the external flap.
7 8
- 8 -
A
6