Using A Camera In Dpof Mode - Sagem PHOTO EASY 255 Livret D'utilisation

The message "Infrared transfer - Please wait" blinks on the printer screen
throughout the transfer operation.
You can now:
• Start printing the transferred photograph, after setting the print format
and number of copies if required.
• Transfer another photograph from your GSM mobile phone camera,
which will be added to those already stored in the printer. At the end of
each transfer, the total number of photographs stored is displayed on the
printer screen (the one with the highest number being the last one
transferred).
• The same operations as described in the previous chapters can now be
performed before starting to print the photographs: (selecting the
photographs to be printed, selecting the format, selecting the number of
copies).
After all photographs transferred from your GSM mobile phone camera have
been printed, the SAGEM PHOTO EASY 255 printer screen displays the
information that was on the screen just before you started the print job.
You can now:
• Start another print job, after selecting different parameters (photograph
number, format, number of copies) if required.
• End the transferred photograph processing. To do this, hold the
down for 3 seconds.
U
SING A CAMERA IN
This function lets you select the photographs to be printed on your camera,
then print them on the SAGEM PHOTO EASY 255 printer from a memory
card. Your camera must comply with the DPOF (Digital Print Order Format)
standard. Refer to your camera documentation to find out if it is compatible
with this standard.
Select the required photographs on the camera (follow the instructions in the
documentation of your camera).
Switch the printer on. Place the memory card into its slot. The following
message is displayed on the screen "Print the camera DPOF selection? - C
: No - OK : Yes".
DPOF
MODE
- 13 -
key