Apex XT Fit Instructions D'utilisation page 22

English
Guidance and Manufacturer's Declaration- Electromagnetic Immunity:
This device is intended for use in the electromagnetic environment specified below. The user of this
English
device should make sure it is used in such an environment.
Immunity Test
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
IEC60601 test level Compliance
3Vrms150 kHz to 3Vrms
80 MHz outside
a
ISM bands
3 V/m 80 MHz to 3V/m
2.5 GHz
18
Electromagnetic
Environment-Guidance
Portable and mobile RF
communications equipment
should be used no closer to
any part of this device,
including cables, than there
commended separation
distance calculated from the
equation applicable to the
frequency of the transmitter.
Recommended separation
distance
150kHz to 80MHz

d 1 2 . P 150kHz to 80MHz
80 MHz to 2.5G
MHz
Where P is the maximum
output power rating of the
transmitter in watts
according to the transmitter
manufacturer and d is the
recommended separation
distance in meters (m).
Field strengths from fixed RF
transmitters, as determined by
an electromagnetic site survey
c
, should be less than the
compliance level in
d
frequency range .
Interference may occur in the
vicinity of equipment marked
with the following symbol:
(W)
b
each