Installation; Installation Considerations - Rockford Fosgate 3SIXTY Installation Et Fonctionnement

INSTALLATION CONSIDERATIONS

As the automotive manufacturers increasingly make their source units (radios) an integral part of the vehicle,
it becomes harder to change them out and upgrade your system.The 3Sixty makes it possible to utilize the
vehicle source unit and still create the sound experience that fits you.With easy to use menus, the 3Sixty
connected to your vehicle's source unit and an amplifier, you can create a sound stage that is personally tuned to
your vehicle.The 3Sixty gives you all the benefits of creating the best system possible without compromising the
manufacturer's integrated source system.
IMPORTANT: To tune the 3Sixty properly to your system, the source unit must have a CD player.Also, the
3Sixty is used as an integration tool for connecting an amplifier and other components to your
existing vehicle source unit.An amplifier with RCA inputs is required to connect the 3Sixty into
your system.A Palm
unit to properly work with your system.
The following is a list of tools needed for installation:
Palm Based Device
Volt/Ohm Meter
Wire strippers
Wire crimpers
Wire cutters
Small Flathead screwdriver
#2 Phillips screwdriver
This section focuses on some of the vehicle considerations for installing your new system.
Pre-planning your system layout and best wiring routes will save installation time.When deciding on the layout of
your new system, be sure that each component will be easily accessible for making adjustments.
CAUTION: If you feel unsure about installing this system yourself, have it installed by a
qualified technician.
CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage
to the unit, fire and/or possible injury.
Before beginning any installation, follow these simple rules:
1. Be sure to carefully read and understand the instructions before attempting to install the unit.
2. For safety, disconnect the negative lead from the battery prior to beginning the installation.
3. For easier assembly, we suggest you run all wires prior to mounting your unit in place.
4. Route all of the RCA cables close together and away from any high current wires.
5. Use high quality connectors for a reliable installation and to minimize signal or power loss.
6. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum
lines or electrical wiring when working on any vehicle.
7. Never run wires underneath the vehicle. Running the wires inside the vehicle provides the best protection.
8. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect any wires
routed through metal, especially the firewall.
9. ALWAYS protect the battery and electrical system from damage with proper fusing. Install the appropriate
fuse holder and fuse on the +12V power wire within 18" (45.7 cm) of the battery terminal.
10. When grounding to the chassis of the vehicle, scrape all paint from the metal to ensure a good, clean ground
connection. Grounding connections should be as short as possible and always be connected to metal that is
welded to the main body, or chassis, of the vehicle.
OS device is also required for initial setup and adjustments for the 3Sixty
®
Battery post wrench
Hand held drill w/assorted bits
1/8" diameter heatshrink tubing
Assorted connectors
Adequate Length—Red Power Wire
Adequate Length—Remote Turn-on Wire
Adequate Length—Black Grounding Wire
I
NSTALLATION
5