Design Features; Bluetooth - Rockford Fosgate 3SIXTY Installation Et Fonctionnement

Masquer les pouces Voir aussi pour 3SIXTY:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

D
F
ESIGN
EATURES
Left Side View
3
INPUT
FRONT
REAR
SUB
R
R
LEVEL
LEVEL
LEVEL
L
L
SIG
CLP
SIG
CLP
SIG
CENTER
4 5 6
4 5 6 4 5 6
1.
Power LED – This red LED flashes while initializing and illuminates when the unit is turned on.
2.
Connection – The Power LED turns Blue when a Bluetooth link is established between the

Bluetooth

®
hardware and the Palm controller.
3.
RCA Input Jacks – The industry standard RCA jacks provide an easy connection for signal level input.
They are nickel-plated to resist the signal degradation caused by corrosion.
4.
SNG LED (Signal Presence) – These Blue LEDs will illuminate when a signal is present at the RCA
Input Jacks or at the High Level Inputs (Speaker) (Except for AUX inputs).
5.
Level Control (Signal Level Sensitivity) – The signal level sensitivity control is present to match the
output of most source units. It can be adjusted to match output levels from a variety of source units.
6.
CLP LED (Clipping) – These Red LEDs will illuminate when a clipping is present at the RCA Output
Jacks (Except for AUX inputs).
7.
High Level Input (Speaker) – The High Level Input uses a detachable connector that will accept
up to 18 AWG wires.This input should be used if the source unit has only speaker line (high level)
outputs and not RCA outputs.
8.
Comm Port (Communication Port) – Connect a Remote Volume-Sub accessory to this port to
control the master volume or subwoofer level.You can also switch between the main and auxiliary inputs
by pressing the knob on the remote. Connection is made with a RJ-45 cable and can be installed in a
variety of ways for easy control access.
9.
Power Connection – This is a detachable connector that will accept up to 18 AWG wires for the
power (B+) and ground (GND).
10. REM Connection – This is part of the detachable power connector and will accept up to a 18 AWG
wire.This terminal is can be used to either remotely turn-on and turn-off the 3Sixty, when +12V DC is
applied, or the connection can be set up to remotely turn-on and turn-off a amplifier.
11. PIN Reset (Personal Identification Number) – Pressing this reset button will reset the Bluetooth
PIN number to default (0000)[four zeros].
12. RCA Output Jacks – The industry standard RCA jacks provide an easy connection to amplifiers.They
are nickel-plated to resist the signal degradation caused by corrosion.
4
Top View
Interactive Signal Processor
Front View
AUX
FRONT
R
LEFT
L
CLP
+ – + – + – + – + – + –
1
HIGH LEVEL INPUT
COMM PORT
POWER
REAR
RIGHT
LEFT
RIGHT CENTER
SUB
B+ REM
7
8
9
10
2
Right Side View
FRONT
GND
OUTPUT
PIN
RESET
9
11
12
REAR
R
SUB
L
CENTER

Publicité

Table des Matières
loading

Table des Matières