Tuning Your System-Xover - Rockford Fosgate 3SIXTY Installation Et Fonctionnement

EQ Link - Front and Rear Channels - 3Sixty.2 Only
4. By selecting EQ Link, the current channel and its stereo mate are linked
together. Any adjustment made to the active channel will also occur on the
mate channel. This mode is recommended for novice users. The title for
that EQ will change to either Front Channels or Rear Channels depending
on the channels you linked.
Home
5. Clicking on the Home icon will return you back to the Tuning Screen.
Xover (Crossover) - 3Sixty.2 Only
6. Clicking on the Xover icon will take you to the crossover adjustment screen.
TUNING YOUR SYSTEM - XOVER (3SIXTY.2 ONLY)
If you are continuing from the previous section then continue to step 1. If you need to load a file or are connecting to
a 3Sixty unit, see Loading a File in section Operation-Files, or Bluetooth Connection at the beginning of section
Operation-Setup.
1. Select the Tune System icon from the main menu to go to the Tuning Screen.
2. Select the speaker icon for the channel you will be adjusting.
3. From the EQ screen, select the Xover icon to take you to the crossover adjustment screen for that channel.
NOTE: You can move quickly to any of the channels by simply touching the speaker icon of the channel
you want in the Channel Jump area.
Xover (Crossover)
Filter Type - Front, Rear and Center Channels
1. The crossovers for each channel can be configured as either high-pass
(HP), low-pass (LP), band-pass (BP) or completely by-passed (AP).
Except the subwoofer channel which is set to low-pass (LP).
Xover Freq (Crossover Frequency)
2. Frequency is adjustable between 50 and 10000Hz in stepped
increments for front, rear and center channels and between
50 and 200Hz for the subwoofer channel
3. When in band-pass mode (BP) there are 2 corner frequencies. The high-pass
frequency is the lowest frequency you want for your speaker while the
low-pass frequency is the highest frequency. See the sample graph.
4. When you select any mode (except AP) the current crossover frequency will
be displayed. Use the arrows to the immediate right of each field to adjust
the frequency up or down.
5. Frequency adjusts in stepped increments, 5 increments between 50 and 100,
10 increments between 100 and 250, 50 increments between 250 and 1000,
250 increments between 1000 and 5000, and 1000 increments between
5000 and 10000.
Xover Slope (Crossover Slope)
6. Select the crossover slope you want, either 12dB/octave or 24dB/octave. The steeper then slope, the faster the
roll-off, resulting in less content passing through the device from the unwanted frequency range.
NOTE: If you are unsure as to the correct setting, consult your local Authorized Rockford Fosgate dealer for
correct recommended setting for your specific system.
Delay
7. Each channel has the ability to be delayed. The delay ranges from 0 to 5 feet in increments of 2 inches.
This feature is used to manipulate the sound field image within the vehicle. Click on the up and down arrows to
adjust the delay.
NOTE: The Xover Link does NOT link the left and right stereo pair delay like it does to the other crossover
settings. Each channel remains independent and must be adjusted as such.
O -T
PERATION UNING
13