MIRKA DEROS 325X CV Instructions D'utilisation page 15

Reducing vibration when sanding with pad saver or interface
When pad saver or interface is used for sanding, this set-up may increase the level of vibration. Your Mirka tool has a
feature that allowing to reduce this vibration. To reduce vibration that may occur when a pad saver or interface is used,
please follow these steps:
1. Disconnect power cable.
Remove backing pad.
2.
Add hex nuts and screws in accordance with the table below, tighten to 2 Nm.
3.
Note! If the sander is used with an interface it is recommended that the speed is set to a maximum of 7,000 rpm.
1. Machine configuration out of box.
3. Machine configuration out of box.
Model
DEROS 550
DEROS 625
DEROS 650
DEROS 680
DEROS 5650
Model
DEROS 550
DEROS 625
DEROS 650
DEROS 680
DEROS 5650
2. Machine configuration for use with pad saver or interface.
4. Machine configuration for use with pad saver or interface.
Picture
A B
1 - X
1 - X
1 - X
3 - X
1 - X
Picture
2 X X
2 - X
2 X X
4 X X
2 X X
Set-up out of box
Screw
C D E
X - -
X - -
X - -
- X X
X - -
Set-up for padsaver/interface
X - -
X - -
X - -
X X X
X - -
Mirka® DEROS & 325X, 350X, 550X, 625X, 650X, 680X & 5650X
Hex nut
A B C D
- - - -
- - - -
- - - -
- - - -
- - - -
X X X -
- X X -
X X X -
- - - -
X X X -
en (original)
E
-
-
-
-
-
-
-
-
-
-
15