WARNING: When the buttons on the remote control handset are released, the caravan will
slowly stop after 0.5 second and continue to move about 6cm (depending on final speed).
When the buttons of the remote control handset are released when the system is still in the
"soft start" stage (slowly speed up), the caravan will stop immediately.
After the "soft start" stage the caravan moves according one fixed speed. The speed can increase a little when
going downhill and decrease a little when going uphill. TIP: The manoeuvring system is more efficient when
reversing the caravan up an incline.
When you are ready with manoeuvring you need to secure the handbrake.
Press at the same time, during at least three seconds, the two buttons for disengaging the motor powered
rollers (Fig. 5J). The blue LED (Fig. 5H) will blink fast during these three seconds and every second there will be
a beep. This warns you that the system will be activated!
After these three seconds the motor powered rollers will be released from the tyre and the blue LED will
illuminate constant, now you can release the two buttons. When the motor powered rollers are completely
disengaged the blue LED will switch off and the system is ready for transport.
After manoeuvring, deactivate the enduro
remote control handset (Fig. 5A). The green LED (Fig. 5H) on the remote control handset will turn off. Store
remote control in a safe place (out of reach of children or other unauthorised people).
Turn off the battery power isolation switch.
Before you start driving always make sure that the both drive units are fully disengaged
into the automatic transit lock!
OPERATION - HITCHING AND UNHITCHING
It is possible to position the caravan's hitch exactly over a stationery car's tow ball using the manoeuvring
system. But please be very careful!
Use the button controls on the remote control to bring the hitch of the caravan to the car. The soft start
technology allows you to locate the tow-ball of the car by centimetre. It is better reach the tow ball with several
short "trips" rather than trying to do it in one "trip".
WARNING: When the buttons on the remote control handset are released, the caravan will
slowly stop after 0.5 second and continue to move about 6cm (depending on final speed).
When the buttons of the remote control handset are released when the system is still in the
"soft start" stage (slowly speed up), the caravan will stop immediately.
When the hitch is right above the tow ball of the vehicle, lower the hitch to the ball and engage in the normal
way using the jockey wheel.
Release the rollers from the caravan's tyres. You cannot tow the caravan with the drive
units are engaged! Make sure that the both drive units are fully disengaged into the
automatic transit lock!
Trying to drive away with the drive units still engaged, will damage the manoeuvring
system, your caravan tyres and strain your tow vehicle!
MAINTENANCE
To prevent the battery from becoming totally discharged during long periods of inactivity it must be
disconnected, fully charged and frost-proof stored.
Please check regularly that the rollers of the drive units are free of any dirt, or debris that may have been
picked up from the road.
Regularly clean the drive units with a water hose to dissolve mud etc.
Please check regularly the distance between the rollers and the tyres. In the neutral (fully disengaged) position
this must be about 20mm.
Once a year have your enduro
inspection must include all the bolt/nut connections, the cables and electrical connections and lubrication of
movable parts/joints.
®
manoeuvring system by moving the slide switch to "Off"-O on the
®
caravan manoeuvring system maintained and visually inspected. This
®
enduro
EM305
34
Ref: EM305-UM-TKI-1110-Rev.A.