Bulb Replacement - Beuchat PHARE 30/50W Ni-MH Manuel D'utilisation

26 > User guide / Bulb replacement
Control before diving :
The reflector must be completely secured (without exces-
sive screwing).
The safety button must be on its locked position (left).
Turning on the Light a few seconds, the red indicator
must be off.
CAUTION :
The use of the guard on the block reflectors masks
threading, it is thus imperative to precisely control
the tightening of the port-hole before dive. Remove
protection, for a visual control or to make screwing
"with the contact", metal on metal, then unscrew of
a few millimetres to release threading.
Light 30 / 50 Watts. Do not turn-on the light for
more than 2 minutes when out of water with a 50
W bulb.

Bulb replacement

How to proceed with the replacement of the bulb :
Make sure the rotating switch is in the off position
1
"Charge - OFF".
Unscrew the reflector.
2
Take the bulb with a clean cloth and remove it.
3
Caution : Don't force the bulb sideways to avoid
breaking the broaches in the glass.
Take the new bulb (with a dry and clean cloth) and
4
insert vertically in its support until it stops.
Screw on the reflector checking the lubrication and
5
cleanness of the O'ring.
Try the new bulb by turning on the Light a few seconds
6
(10 seconds maximum).The bulb must remain clear.