Using The Tool - Hoover SteamVac F5808 Manuel De L'utilisateur

La shampouineuse en profondeur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3-5
Push attachment against nozzle while rotat-
ing attachment downward until both ends
snap into place.
(Note: Some force may be required to
rotate and snap attachment into place.)
Return carpet cleaner to upright position.
Lower handle and replace recovery tank.
Raise handle to upright position and
reposition clean solution tank.
3-7
B
2. Step on handle release pedal (B) and
lower carpet cleaner handle until it rests
on the floor.
Unlatch back part of recovery tank and
remove lid.
12
To clean floor
Read Before you begin cleaning
instructions on page 10.
Do not use the SteamVac™ carpet
cleaner on hardwood floors.
Fill clean solution tank with HOOVER
Hard Floor Cleaning Solution (available at
additional cost if not included with your
model) according to instructions on
pages 7 and 8.
Do not use any type of wax with your
SteamVac™ carpet cleaner.
Dry hands and plug carpet cleaner into
a properly grounded outlet.
Step on handle release pedal and lower
handle to operating position; turn carpet
cleaner ON.
To release solution, press trigger. Slowly
move carpet cleaner forward and back-
ward over area to be cleaned.
To pick up dirty solution, release trigger
and slowly move carpet cleaner over
area where solution has just been dis-
persed. Use both forward and reverse
strokes.
Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-off", page 7).
When finished cleaning, follow "After
cleaning" instructions on page 10.
Remove attachment from nozzle and
rinse in clear water. Do not remove
plastic screen or foam from attach-
ment.
3-8
3. Remove recovery tank front panel (C)
by sliding it straight up.

Using the tool

How to attach hose
Disconnect carpet cleaner from elec-
trical outlet.
3-6
1. To prevent possible leaking, remove
clean solution tank by pressing down on
tank handle (A) and pulling forward; set
tank aside (do not set tank on furniture).
Remove hose from storage rack.
3-9
C
4. Replace panel with converter (D).
Slide converter halfway down opening
until it is firmly in place.
A
D

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Steamvac f5810-900

Table des Matières