Hoover SteamVac F5808 Manuel De L'utilisateur page 7

2-2
A
ON/OFF pedal &
Handle release pedal
Step on pedal (A) to turn carpet cleaner
on. Step on pedal again to turn carpet
cleaner off.
Step on pedal (B) to lower handle to
operating position. Handle does not lock
into a single position but "floats" to allow
convenient operation.
2-5
The carpet cleaner may also be lifted by
placing a hand under the clean solution
tank handle as shown.
2-3
B
Automatic "shut-off"
When the recovery tank (lower tank) is full
the automatic shutoff mechanism will shut
off the carpet cleaner suction (suction will
be noticeably reduced).
At that time the yellow float disk will rise
to the top of the recovery tank lid (C).
The carpet cleaner will no longer pick
up dirty solution and the motor sound
will become noticeably higher in
pitch.
When this happens turn carpet clean-
er off and empty recovery tank before
continuing use.
Check clean solution tank also; it may
need to be refilled.
2-6
The tanks
Clean solution tank
(upper tank)
The clean solution tank holds the clean-
ing solution that is to be dispersed onto
the surface to be cleaned.
How to fill
Disconnect carpet cleaner from
electrical outlet.
Place carpet cleaner handle in the
upright, locked position.
To remove tank, press down on handle
(D) and pull forward.
2-4
C
To transport
To move your carpet cleaner from room
to room put handle in upright and
locked position tilt carpet cleaner back
on wheels and push forward.
2-7
D
Carry tank to a sink.
Rotate tank cap counterclockwise and
lift up to remove cap.
Continued 7