Hoover SteamVac F5808 Manuel De L'utilisateur page 4

Assembled models with attached tools will
look like this drawing.
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from carpet cleaner.
1-5
Push bolts into holes on front of handle. If
bolts will not go through hole easily han-
dle is not pushed completely down.
4
Assembled models without attached
tools will look like this drawing.
1-3
Remove nozzle stored on upper handle by
gently pushing nozzle downward while piv-
oting it away from the handle at (A).
1-6
Place nuts in recessed areas on back
of handle. Hold each nut in place while
tightening each bolt securely (from the
front of the handle) with a Phillips
screwdriver.
Only two nuts are needed on this
model. The extra nut is not required but
has been provided for your conve-
nience.
1-4
A
With cord hook (B) to back of carpet clean-
er, push upper handle down onto lower
handle.
1-7
When handle sections are completely
together, squeeze trigger (C) on upper
handle to snap trigger rod in place.
B
C