CLAS OP 1338 Mode D'emploi page 13

OP 1338
Packaging and storage
The spray gun is supplied in single card boxes in the format 29,5x26,5x8 cm, gross weight 1,600 Kg, net weight
1,200 Kg (gun only). The product must be stored in environments protected against humidity, at temperatures
between -15°C and + 50°C..
Never use the gun in the vicinity of or in potentially explosive atmospheres (standard 94/9/EC Atex).
Never use solvents and/or detergents with a halogenated hydrocarbon base (Methyl chloride, Dichloromethane,
1.2-Dichloroethane, Carbon tetrachloride, Trichloroethylene, 1.1.1-Trichloroethane) on aluminium and/or
galvanised components of the gun, as these may cause chemical reactions such as oxidation, and in more extreme
cases could lead to explosive reactions. For cleaning, use exclusively diluent and detergent substances that do not
contain the components listed above. In the same case, never use strong acid or alkaline base solutions for these
procedures.
This symbol draws your attention to safety related issues.
Read carefully the recommendations included and strictly comply with them.
Before using the gun, ensure you have read and fully observe all instructions for use.
Before any repair or maintenance operations, disconnect the gun from the air supply.
When choosing the spray product and before using the gun, check the product compatibility with the work
environment and the adopted personal protective equipment, according to the relative safety data sheet. environment and the adopted personal protective equipment, according to the relative safety data sheet.
In the event of pauses during work, always keep the cartridge inserted in the gun to ensure airtight closure;
otherwise clean the gun according to the relative instructions.
otherwise clean the gun according to the relative instructions.
Never turn the gun spray towards yourself, other people, animals or objects, other than the object undergoing
treatment.
During use, always wear the speci ed personal protective clothing and equipment (gloves, goggles, mask,
overalls etc.) according to the instructions in the safety data sheet of the product used. In any event, the use of
protection goggles is always recommended.
protection goggles is always recommended.
Hang the gun up on the relative hook when not used.
Intended use
• Only proceed with operations after reading and understanding this manual
• Spraying and extrusion of sealing products, polymer and polyurethane base cartridges (Ms polymer), protective
and sound-proo ng products in special cartridges
• Work in environments suitable for the speci c products
• Use exclusively products suitable for the intended type of spray (MS-Polymer).
Forbiden use
• Exclusion of any speci c product, other than those listed above
• Any use other than the spraying of the aforementioned dedicated products
• Failure to use the personal protective equipment during operation
• Work in potentially explosive atmospheres and/or use of products generating potentially explosive atmospheres
• Use of hydrogenated hydrocarbons as detergent liquids (see warnings)
• Use of the gun without rst reading and understanding the contents of this manual and, on each change of
CARTRIDGE SPRAY GUN (POLYMER MS)
SAFETY
USES