Niko 05-350 Mode D'emploi page 46

05-350 / 05-338
mode 3: Preset (light scene). With one push button programmed in mode 3 you can call a
previously programmed light value. Method: The desired channel is switched on
by previously programmed push buttons and set to the desired light value. You can
now set mode 3 for the channel and allocate the light value to a push button by
programming. The programming is subsequently ended.
mode 4: Light scene. With one push button programmed in mode 4 you can call and save
a light value.
Long press (>1.6s) = to save a light value. The previous value is overwritten.
Brief press (<1.6s) = to call a light value.
Method: The desired channel is switched on by previously programmed push but-
tons and set to the desired light value. You can now set mode 4 for the channel
and allocate the light value to a push button by programming. The programming is
subsequently ended.
If you want to change the scene settings, reprogramming is not necessary.
Program the scene with the push buttons, press long on the push button (in m4)
and the new scene will be saved.
mode 7: Dim off with minimum 3min release time. The time can be extended by setting time
T (see table of time functions).
E.g. T=30s; the release time then becomes 3min + 30s = 3'30".
46 EN