Niko 05-350 Mode D'emploi page 39

05-350 / 05-338
Read the complete manual before attempting installation and activating the system.
1. DESCRIPTION
This Easywave receiver is part of the Niko RF (Radio Frequency) system, an installation
technique that does not use any wiring between the control points (push buttons) and the
consumers to be operated. This technique is known as 'remote control' or 'wireless control'.
Transmission occurs by means of radio waves at the 868.3 MHz frequency. This frequency is
reserved for products that do not transmit continuously (1% per hour = 36s), so that there is
only a minimal risk of interference. The system is therefore ideally suited for use in specific
applications such as renovation of interiors, extensions in existing electrical installations where
drilling or channeling work is excluded, offices with movable walls... or to avoid the use of
complex cabling configurations. It is a modular system built around transmitters and receivers.
The wall-mount transmitters take the form of an ordinary switch suited for wall mounting. The
hand-held transmitters take the form of a conventional remote control unit. Each transmitter
can control an unlimited number of receivers simultaneously. Each receiver can be controlled
by up to 32 transmitters.
ATTENTION! When mounting the receiver in a metal distribution box, external antenna 05-309
has to be used. The antenna does not extend the available range. Through-feed opening for
the connector: approx. 15mm.
EN 39