Control Panel - Vitamix S50 Manuel D'utilisation

S50
1. Power Indication: When the stop symbol (O) brightens, this indicates that the machine is plugged in
and power is flowing. Unplug the machine whenever it will be left unattended.
The stop symbol on the control panel will behave in these ways:
Slow flash – machine is plugged in but the container is not properly in place on the motor base.
Solid (no flash) – machine is plugged in, the container is in place, and the machine is ready to blend.
Fast flash – error caused by one of the following:
A.
The motor base is plugged in while the control knob is not in the stop position (O).
B. The container was placed on the machine while the control knob was not pointed at the stop
symbol (O).
C.
The container was removed from machine while operating (could include lifting the container away
from the motor base and the interlock tabs losing contact with the base during tamping).
If the container is lifted or rocked from the motor base during blending, the machine will turn off
automatically. To continue, place the container back on the motor base. Push in on the center of the
control knob to start the blades.
2. Control Knob: Allows you to select a program or use variable speed from 1 to 10 (low to high).
To begin, rotate the control knob counterclockwise from the stop symbol to select a program or
clockwise from the stop symbol to the desired variable speed setting. Push in on the center of the knob
to activate the blades. When blending with a program, allow the blender to blend through the cycle and
stop on it's own. When using variable speed, push in on the center of the control knob again to stop the
blades. Rotate the control knob back to the stop symbol.
3. Pulse ( ): Rotate the control knob to the counterclockwise to the pulse position. Push in on the
center of the control knob to activate the blades. The machine will blend at 50% of high speed for as
long as it is held in this position.
4. Programs: Your blender is equipped with two program settings. Rotating the control knob
counterclockwise from the stop symbol allows you to select a program for Smoothies (
Blends ( ). Program blending speeds and duration vary and will stop automatically at the end of the
program. To begin a program, rotate to the icon and then press in on the center of the control knob to
activate the blades. To stop, push in again on the center of the control knob. Rotate the control knob back
to the stop symbol when done.
8
CO N T R O L PA N E L
1
3
4
2
) and Power