Astralpool LUMIPLUS RGB Manuel D'installation Et D'entretien page 2

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be implemented
for installation and start-up. Therefore, the installer as well as the user must read the instructions before beginning installation
and start-up.
Keep this manual for future reference.
To achieve optimum performance of the CONTROL SYSTEM FOR LUMIPLUS PROJECTORS RGB, follow the instructions
indicated below:
1. DESCRIPTION
There are two types of controls:
1. LumiPlus Modulator (27818)
2. LumiPlus Modulator (27818) + LumiPlus Remote Control (41988)
The Modulator has a status indicator LED in the lower part of the set, and IP65 antenna
and 4 pushbuttons: COLOR, SEQUENCE, SPEED and
The main functions of the Modulator are:
 Switching the projectors on/off.
 Colour selection: 12 fixed colours available.
 Sequence selection: 8 sequences available.
 Sequence speed selection: 8 speeds available per sequence.
1.1 INSTALLATION
 Install the Modulator protected from corrosive
environments, away from metal boxes and metal
piping or electrical wiring.
 The Modulator is connected to the 230 Vac mains
through two terminals indicated RED (MAINS). It
is connected to the transformer primary (230 Vac)
through the terminals indicated TRF (see attached
diagram).
 Both the transformer/s and the modulator/s must be of
sufficient size to supply the VA corresponding to the projectors
installed. The Modulator can withstand up to 900VA. For each
projector, its power and the number of units that can be connected to a
modulator are specified in the respective manual. The diagram is valid for
the whole range of Lumiplus RGB projectors.
ANTENNA
The Modulator can be controlled by the LumiPlus Remote Control, for more
convenience.
The Modulator incorporates an antenna to receive the signal from the Remote
Control. The antenna can be installed anywhere, but always avoiding corrosive
environments and away from metal boxes and metal piping or electrical wiring,
which block the Radio Frequency signal from the Remote Control. If the
Modulator does not detect any signal, move the antenna. The cable, which is non-
polarized, must be connected to terminals 31 and 32 of the Modulator.
1. LUMIPLUS MODULATOR
/ SLEEP.
2
Projector
Power supply