Overall Dimensions - Ecoflam Max Gas 170 P Mode D'emploi

Masquer les pouces Voir aussi pour Max Gas 170 P:

Notice d'emploi (64 pages)

Table Des Matières

Table des Matières

Les langues disponibles

MAX GAS 170-250 P

MODEL

MAX GAS 170 P

392

MAX GAS 170 PAB

452

MAX GAS 250 P

392

MAX GAS 250 PAB

452

Installation must be carried out in compliance with the local provisions

4,0

3,0

2,0

1,0

0,6

0,5

0,4

d=0,3

0,3

d=0,225

0,2

0,1

(a)

d = diam tre chambre de combustion

PRELIMINARY CHECKS

Before starting up the boiler check the following: - gas type and feed pressure; - gas valves closed; - the seals in the pipe

fittings; - gas pipe breather and input pressure; - that the cable complies with the diagram and the phase and neutral

wires correspond; - that the burner shuts down when the boiler thermostat opens; - the seal of the boiler furnace which

prevents air from entering; - the seal on the flue-boiler pipe fitting; - the condition of the flue (sealed, free from blocka-

ge, etc ). If all these conditions are present, start the burner. The control device starts the motor to carry out prewashing

of the combustion chamber. During this prewash period (about 30 seconds) the device checks that air pressure is correct

via the air pressure switch. At the end, it supplies power to the transformer and opens the gas valves. The flame must be

lit and stabilize within 3 seconds, which is the device's safety time limit. Check to ensure the flame is lit before placing

any control instrument in the flue. Adjust and check the gas flow necessary for the boiler at the meter. Adjust the air

flow according to the gas flow to obtain correct combustion.

IMPORTANT ADVICE

All adjustable parts must be fixed by the installer after making adjustments. Check flue combustion after each adjusti-

ment. The CO

values must be approx. 9.7 (G20) 9.6 (G25) 11.7 (G30) 11.7 (G31) and the CO must be less than 75

ppm.