Publicité
1 7
1 9
9
Installation Instructions
UNDER COUNTER INSTALLATIONS:
1. First, make sure the clearance between the
backsplash, faucet, fixtures and cabinets
are acceptable for the new sink.
For ADA compliance, all models must be
installed with the overflow in the rear.
NOTE: To avoid damage to countertop,
install sink such that future removal from
underneath the countertop is possible.
2. Carefully cut out the enclosed template,
then position and trace the template on the
countertop as shown on the template. Make
a mark of the faucet hole centerline on the
countertop. Drill a 1/2" pilot hole on the inside
of the cut line. Use a saber saw or a keyhole
saw to cut out the countertop opening.
3. Mark and pre-drill the wood screw holes as
located on the enclosed template. Waterproof
any exposed areas of wood.
4. To protect countertop, place it on a foam pad-
ding and drill 3/8" (10 mm) Dia. X 1/2" (13 mm)
deep hole as per location shown on template.
39660000/3967300
Eurocube / Essence
Drop-in and Under Counter Lavatories
Lavabos à encastrer ou à installer sous le comptoir
Lavabos para sobreponer y para colocar debajo de la mesada
SHUT-OFF VALVES
SOUPAPES DE FERMETURE
ALLAVE DEPASO
5. Mount the drain assembly (not included)
on the sink, following faucet manufacturer's
instructions. Be certain to apply a bead of
sealing putty on the underside of the drain
(Part "A") in order to ensure a watertight seal
between the sink and drain. Remove excess
putty after installing drain on sink.
6. Do not use adhesives or adhesive sealants.
After checking fit and alignment of sink to cut
out, apply a bead of silicone adhesive to rim
of sink.
7. Center bowl over cutout and tighten screws
(see 3 or 4) to secure bowl to countertop.
Remove excess sealant from inside lip.
NOTE: The screws provided should be used
on countertops with a minimum 1" (25 mm)
thickness. For thinner countertops, use
appropriate anchors and fasteners.
8. Install faucet (not included) and countertop
(not included) following manufacturers
instructions.
1 8
1 10
9. Connect supply line to faucet (finger tight)
and carefully bend tubes to engage with the
supply shut-off valves. Tighten connections at
faucet and shut-off valves for water tight seal.
10. Connect trap to drain assembly hand tight
to check alignment. It may be necessary to
cut off part of the tailpiece (area "B") or part
of the horizontal leg of the trap (area "C").
Secure joints for watertight assembly.
C
B
7302455-100 (8/19)
Publicité
